Remote control problem with Hyperion

Hello I had intended to try this firmware 91HD .. 
I managed to install the firmware via usb on the guide I found in this forum but with both versions remain stuck in the initial configuration screen, where you should select the video output (component, hdmi, scart) 
I can not make it ok with the remote control it with the buttons on the receiver. 
How can I fix the problem?

Did you fix it?

Hello "an3a".
I have ipbox91, but never try Hyperion img.mod usb, only other img. flash.
I descovered that some img. dont work with remote ( on this commands (component, hdmi, scart) )...soo I renunced on them...

ps:  will you share the mod to install this img.mod usb in my ipbox91( your help will be apriciate ).

happyboy wrote:

Hello "an3a".
I have ipbox91, but never try Hyperion img.mod usb, only other img. flash.
I descovered that some img. dont work with remote ( on this commands (component, hdmi, scart) )...soo I renunced on them...

ps:  will you share the mod to install this img.mod usb in my ipbox91( your help will be apriciate ).

Hi,
I tried this image and I had the same problem with the remote control.
I solved this problem in this way:
1) I installed in the flash a DGS based firmware (094-13791-Full-Extended-4.4-Ocean-91)
2) I installed the multiboot (Multiboot IpBox serie 9xxx) (choosing the one for ipbox91hd)
3) I prepared a usb pen with the first primary partition of 512Mbytes

In this way I have solved the problem and installed the hyperion 4 (an eccellent firmware !!!).
Best regards,
Scipione